Fireplace Ordering (44 Photos): Drawing And Procedure For Making Models With A Stove Bench And Increased Heat Transfer, Annushka And A Barbecue

Table of contents:

Fireplace Ordering (44 Photos): Drawing And Procedure For Making Models With A Stove Bench And Increased Heat Transfer, Annushka And A Barbecue
Fireplace Ordering (44 Photos): Drawing And Procedure For Making Models With A Stove Bench And Increased Heat Transfer, Annushka And A Barbecue

Video: Fireplace Ordering (44 Photos): Drawing And Procedure For Making Models With A Stove Bench And Increased Heat Transfer, Annushka And A Barbecue

Отличия серверных жестких дисков от десктопных
Video: Grill Buying Guide (Interactive Video) | Consumer Reports 2023, January
Anonim

Ordering is one of the most important stages in the construction of a fireplace. It is needed in order to correctly carry out the future laying of the fireplace itself. The final result depends on the correctness of its preparation and planning. To protect yourself from unnecessary mistakes and waste, it is necessary to draw up a diagram of the fireplace masonry.

Image
Image
Image
Image

If you wish, you can create such a scheme with the ordering of the fireplace yourself, or you can use ready-made samples or the services of qualified craftsmen. Thus, you can independently perform various orders, as well as, for example, the order of a stove with a heating shield.

Image
Image

What is required

To order the fireplace yourself at home, you just need a checkered sheet, a pen and calculated data for the future plan. And, of course, some of your attention and patience. If you choose an order from ready-made options for drawings, then first you should pay attention to the area of ​​the room where you decided to build a fireplace.

Image
Image

Classic

You can use this order for a fireplace that will be located in a medium or large room. In addition, the classic ordering is used for a simple brick hearth. The classic option for ordering the fireplace is beneficial in that you can re-plan it yourself, and it will not take you much time.

Image
Image

To make a classic or simple order, you must follow the instructions.

At the first stage, if you want to get an unusual and uncomplicated appearance of the fireplace, the basement row must be laid out on the edge. When forming this row, it is best to use a prepared drawing. In addition, a diagram - a drawing will greatly simplify your task and help you place all the stages in turn.

Image
Image

In the second and third stages, the laying is performed flat, i.e. layer. From the first to the third rows, it is worth filling with building materials. The fourth row is the lower horizontal surface in the fireplace. It folds according to your drawing.

Image
Image

At the fourth stage, it is necessary to make a blower. A wood-burning fireplace or stove should always have a place for collecting waste products of combustion. In addition, here it is necessary to make a lattice, most often, metal options are made. This grid will be needed for the next fifth row, you will lay it on the bricks. In the next step, press the metal grate with the next layer.

Image
Image
Image
Image

In the sixth and seventh stages, it is necessary to start laying the portal. Laying must start from the bottom. The portal should be built up to the thirteenth row. It is worth noting that on the eleventh row it is necessary to make a special mirrored tilt. At the eighth stage, the formation of the slope should be completed, this will be the sixteenth row. The laying must be continued up to the seventeenth row and then the formation of the facade must begin.

Image
Image
Image
Image

At the next stage, on the nineteenth row, you need to start laying out the chimney. On the twenty-second row, a valve should be placed that will close the fireplace or stove.

Image
Image

And finally, in the last, tenth step, you can create the desired shape of the chimney. A brick fireplace made according to these instructions will have increased heat transfer and heat even large rooms.

Image
Image

For corner fireplace

As stated, the ordering is a detailed diagram that indicates the position of each brick.In addition, ordering will greatly simplify your task and help you calculate the required number of bricks that you will need when building a stove or fireplace, moreover, you can avoid unnecessary waste.

The order of a corner fireplace is practically the same as a simple or classic version, you just need to consider a couple of points. One of these important points is that the foundation should rise 10 centimeters above the floor. You can perform this order by following the instructions.

Image
Image
Image
Image

At the first stage, it is recommended to lay the base on clay mortar. Continue to do it until the fourth position (row), where it is necessary to divide the fireplace into two blocks, covered by a stove.

Image
Image

Second phase. The first block should be designed for a log niche, and the second block for a front facade. At the next stage, it is recommended to use refractory bricks; here, a base for the furnace should be formed.

Image
Image

At the fourth stage, after covering the fireplace itself with a slab of hard metal, for example, steel, the construction of the fireplace should take place according to a previously prepared scheme up to the twelfth row. In order for the entire heating system to work efficiently and without any failures, it is also better to use refractory bricks for interior wall decoration.

Image
Image

At the next stage, it is necessary to continue laying, as at the beginning, according to a previously prepared scheme, up to the twenty-seventh row. If you want to make additional rigidity, then you can install iron corners between the bricks. They can be crafted by hand.

And finally, at the sixth stage, it is necessary to make valves on top of the building. The corner laying of the fireplace differs in many respects from the classic one, but it is not at all impracticable.

Image
Image
Image
Image
Image
Image
Image
Image
Image
Image

7 pictures

For an English fireplace

An English wall fireplace has a specific hearth with a straight chimney. In addition, in the drawing or project of such a fireplace, a trapezoidal cut should be made in order for the heat to flow directly into the room.

Image
Image

Following the instructions, you can independently complete the order of the English fireplace.

To start ordering, it is advisable to use ceramic bricks. The first row must be done with the side of the brick. Further and in subsequent stages, the brick should be laid flat. Do not forget that the ordering of an English fireplace does not provide for the presence of a blower and a grate. Most often, blower stoves should be in the design for large rooms. You can use various sheets of metal as elements for fasteners.

Image
Image

Further, the metal fasteners should be covered with four rows of bricks. On the sixteenth row, leave a small hole in the back for heating equipment.

The variant of the English ordering assumes the location of the oven in an open form. The firebox should be lined with refractory building materials. In addition, many people forget about the peculiarities of water absorption by brick, so it is recommended to soak the brick before laying. After completion of construction work, you should wait a few weeks until the brick is completely dry. And only after drying, the fireplace can be put into operation.

Image
Image

Other options

Based on the previous orders, you can easily carry out the ordering of the oven - Dutch or Swedish. The main thing is to make the right drawing and plan everything clearly.

Image
Image

In addition, ordering a fireplace for a barbecue with a cauldron can be a very interesting option for creating with your own hands. The project of ordering such a fireplace is simple and is a brick cabinet with a recess for a kettle. The whole structure is quite lightweight, which is why you can do without a bulky foundation.

Image
Image

If you love baking homemade bread, why not consider ordering with a bread chamber? A fireplace stove with a bread maker is quite relevant lately. The ordering of the stove with a stove bench can be no less interesting; such a stove is considered unique due to the fact that it combines not only heating functions, but also the possibility of cooking. Such a stove will allow you to feel and touch Russian traditions.

Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image

You can also order the bell furnace. Such a design will not only heat the room, but also effectively retain heat in it. Bell-type fireplace - the stove will be a good solution for installation in a country house.

Image
Image
Image
Image
Image
Image
Image
Image
Image
Image

7 pictures

Popular by topic